Parkings
Parkings are estimated according to the parameters set in the trip detector when configuring a unit. To get the information as accurate as possible, it is advised that you configure each parameter individually for every piece of equipment.
A parking is an interval of time when the following conditions are met:
- Insignificant speed. The speed detected must fall in the range from 0 to the Minimum moving speed. When this speed is reached, the behavior of the unit is regarded as a movement (=trip), if by the time and distance travelled it corresponds to the trip definition (the Minimum trip time and Minimum trip distance parameters). The parking, respectively, ends. However, if the time or distance travelled does not fit the scope of the trip, the parking is prolonged.
- Sufficient time interval. This speed must continue for a period of time (and not less than Minimum parking time). If this time is not reached, the behavior of the unit is not regarded as parking, but as a stop.
- Insignificant location change. As it has been noted above, parking is also considered an insignificant movement in space, that is, a movement that does not exceed the Minimum trip distance parameter, if it is equal to or greater than the Minimum parking time parameter.
The information which can be presented in this kind of report is described below.
Column | Description |
---|---|
Beginning | The time when the parking started. |
End | The time when the parking ended. |
Duration | The time interval of a parking. |
Total time | The time from the beginning of the first parking to the end of the last parking. |
Off-time | The time interval from the end of the previous parking to the beginning of the current parking (defined starting from the second parking). |
Location | The address where the unit was stationary. If there was an insignificant movement detected, the initial unit location is indicated. If the unit location is not available during the parking interval, then it is determined by the initial unit location on the trip that follows the parking. |
Count | The number of parkings (useful when grouping rows by years/months/weeks/days/shifts or for the reports on unit groups). |
Notes | An empty column for your custom comments. |
See Data in reports to learn how time (duration) can be formatted.
The interval filtration (by parking duration, sensor state, etc.) can be applied to this table.
The parkings can be displayed on the map. To make use of this feature, select Parking markers in the report template.
Parkings should be distinguished from stops.
Was this helpful?
Download
All pages
Only this page