Fleetrun
Hecterra
NimBus
Other apps
Wialon for Android/iOS
Logistics
Wialon Local
Wialon Hosting
WiaTag
Configurator
LeaseControl
en
Contents
Check Points
  • tables
  • routes

Route points refer to check points indicated when creating a route. The table can include the columns described below.

ColumnDescription
Point nameThe name which is given to this checkpoint while creating it.
Real arrivalThe time when the unit entered the checkpoint.
Scheduled arrivalThe time when the unit was supposed to enter the checkpoint according to the schedule.
Initial locationThe location at the time of entry.
Real departureThe time when the unit left the checkpoint.
Scheduled departureThe time when the unit was supposed to leave the checkpoint according to the schedule.
Final locationThe location at the time of departure.
ResultVisited (both entrance and exit were detected), Entrance only, Exit only, Skipped, Finished (entrance to the last point was detected).
RouteThe name of the route to which this checkpoint belongs.
ScheduleThe name of the schedule.
RideThe name of the ride.
Arrival time deviationA positive value if delayed, negative value if in a hurry in regards to the arrival time set in the point properties.
Departure time deviationA positive value if delayed, negative value if in a hurry in regards to the departure time set in the point properties.
Presence durationThe time spent at the checkpoint.
Presence mileageThe mileage at the checkpoint.
Section durationThe time spent to travel from the previous checkpoint to the current one.
Section mileageThe mileage from the previous checkpoint.
CountThe number of points.
DriverThe name of the driver (if available).
TrailerThe name of the trailer (if it was assigned).
NotesAn empty column for your custom comments.

Questions and answers

  Reports show incorrect mileage. What should I do?

Possible explanations and actions:

1. Outliers of data.

To detect such outliers, build a track of unit movement for the appropriate period. Outliers of data will be seen on the track as dashed lines.

Ways to overcome outliers:

  • Enable filtration of unit positional information in messages (on the Advanced tab of unit properties). This will not affect old messages but applied to new ones.
  • To correct data in reports, change settings of trip detection, in particular, reduce Maximum interval between messages and increase Minimum satellites.

2. Incorrect settings or operation of the mileage counter.

  • Check the mileage counter settings on the General tab of unit properties.

  Do reports display the data on the manual assignment of the driver after the data storage period expires?

Yes, but only if the driver has not had other assignments since they were last assigned to the unit.

If you find a mistake in the text, please select it and press Ctrl+Enter.
Thank you for your feedback!
Report a mistake
Text with the mistake Comment
Maximum 500 characters